It is possible for the load on a circuit to not match the load of all of the devices circuited to it. There is a command in Design Master that will guarantee that the load on each circuit is correct.
To recalculate all circuit loads, go to
DM Electrical
Database UtilitiesRecalculate All Circuit Loads
This command will begin a routine that checks every drawing and every record in the database to make sure each circuit contains the most recent loads. Once each circuit has been updated, the load totals on every panel will also be updated, beginning with the bottom panel and working up. If you wish to recalculate less information than this command provides, see the Recalculating Circuit and Panel Loads page.