For quality control purposes, you may wish to have Design Master highlight any devices that have not yet been circuited.
Open the drawing you wish to check and go to
DM Electrical
Circuiting and HomerunsHighlight Uncircuited Devices
Design Master will draw a line from the 0,0 point on the drawing to each device that is not circuited. Design Master will also show you the following message regarding the lines and how to erase them.
You may press OK to return to the drawing, which will now look like this:
The lines may be erased using AutoCAD commands when they are no longer needed.
The Highlight Uncircuited Devices command does not highlight devices with no load.
Only devices on the drawing in which the command has been run will be highlighted. Highlight Uncircuited Devices must be run in each drawing to highlight all uncircuited devices in the project.