Create Arc-Flash Stickers

The Create Arc-Flash Stickers command is used to create a sticker for each one-line device that has Calculate Arc-Flash checked using the Set Arc-Flash Values command.

If the incident energy at the device is less than 40 J/cm2, a warning label will be printed. If the incident energy is greater than 40 J/cm2, a danger label will be printed.

The sticker will also display the shock protection information for the device. Shock protection is a function of the voltage of the device. Shock protection values are based upon NFPA 70E-2012, Table 130.4(C)(a).

To create arc-flash stickers, go to

DM Electrical->One-Line Schedules->Create Arc-Flash Stickers

Create Arc-Flash Stickers Dialog Box

One-Line Schedules--Create Arc-Flash Stickers dialog box

One-Line Devices: As a list of all one-line devices inserted on the drawing.

Create Stickers for All One-Line Devices: Press this button to create stickers for all of the one-line devices in the project.

Create Stickers for Selected One-Line Devices: Press this button to create stickers for the selected one-line devices.

Creating Arc-Flash Stickers

Examples of the two types of stickers created are shown below:


Page url:
©2012 Design Master Software, Inc