Fault

Creates a schedule called FAULT CURRENT SCHEDULE and sets it to the active view. If a schedule of that name already exists, this command sets the schedule to the active view but does not otherwise modify it.

The default schedule layout is shown below. Information about the fault at each piece of distribution equipment in the project is listed. The devices are ordered based upon the connections between devices in the model.

The FAULT AT DEVICE column uses the DMET_Fault_FaultAtDevice shared parameter by default. This parameter displays a warning in the value for any fault values that exceed that AIC Rating of the distribution equipment. To display the fault without any warnings, replace the column with the DMET_Fault_FaultAtDevice_NoWarnings shared parameter.

Once the schedule is created, you can modify it using standard Revit tools.

fault-current-schedule

Related Options

Output shared parameter values as uppercase: Sets whether shared parameter outputs are displayed only in uppercase letters.

Feeder wire make-up length: Sets additional length to be added to feeders for connections.


Page url: http://www.designmaster.biz/docs/elecrt/2.0/index.html?fault.htm
©2013-2021 Design Master Software, Inc