Adjust Transition Length

To adjust the length of a transition, go to

Ribbon: DM HVAC->Ducts-> dm_hvac-fittingtransitionstretch Adjust Transition Length

Pulldown Menu: DM HVAC->Fittings->Adjust Transition Length

You will be prompted to specify a new end point for a transition on the drawing.

Select duct or label at end of transition:

Select a point on the next duct where the transition will end. The transition will extend from the duct intersection toward the next duct. See the Previous and Next Ducts section for information on determining which duct is the next duct.

The end of the transition will be adjusted to the selected location.

Related Options

Angle of transitions: Sets the default angle of duct transitions.

Page url:
©2012-2018 Design Master Software, Inc