This section describes the command used to generate sections.

When you add or remove ducts and mechanical equipment to a section, you must work on the drawing where those items are inserted. The section can be inserted on any drawing in the project. It does not have to be inserted on the same drawing as where the ducts and mechanical equipment are inserted.

The sections are drawn using 3D entities. If you view the drawing in an isometric view, you will see the 3D section entities. They are rotated so that they appear correctly as 2D ducts when viewed from the top.

They are inserted on the 2D layers. Their appearance is controlled with the other 2D ductwork and not with the 3D ductwork.

Page url:
©2012-2018 Design Master Software, Inc