Split Fitting

To insert a split fitting, go to

DM HVAC->Fittings->Split Fitting

You will be prompted to specify the duct on which a split fitting is to be inserted.

Select duct or label to insert fitting at:

After selecting the duct or label, the Split Fitting Radius dialog box will appear.

split-fitting-radius

Square Elbow with Turning Vanes: Select this option to insert square elbows in the fitting with turning vanes included in them. Turning vanes will only be shown if the shape of the ductwork is rectangular. Turning vanes are never shown on round or flat elbow ductwork.

Square Elbow without Turning Vanes: Select this option to insert square elbows in the fitting without turning vanes included in them.

Radius Elbow: Select this option to insert radius elbows in the fitting. Specify the radius multiplier for the fitting. The radius of the centerline of the fitting will be this value multiplied by the width of the duct.

Select the elbow type for the fitting and press OK. A split fitting with the specified type of elbows will be inserted on the drawing.

fitting-split


Page url: http://www.designmaster.biz/docs/hvac/index.html?split_fitting.htm
©2012-2013 Design Master Software, Inc