Wye / Bullnose Tee

To insert a wye or bullnose tee fitting, go to

DM HVAC->Fittings->Wye / Bullnose Tee

You will be prompted to specify the duct on which a wye or bullnose tee is to be inserted.

Select duct or label to insert fitting at:

After selecting the duct or label, the Turning Vanes? dialog box will appear.

Fittings--Turning Vanes dialog box

Yes: Turning vanes will be inserted in the wye. Turning vanes will only be shown if the shape of the ductwork is rectangular. Turning vanes are never shown on round or flat elbow ductwork.

No: Turning vanes will not be inserted in the wye.

After selecting the duct, a wye or bullnose tee fitting will be inserted on the drawing. The specific fitting that is inserted depends upon the configuration of the duct centerlines. If the centerlines form right-angles, a bullnose tee will be inserted. Otherwise, a wye will be inserted.

fitting-wye


Page url: http://www.designmaster.biz/docs/hvac/index.html?wye_bullnose_tee.htm
©2012-2013 Design Master Software, Inc