Skip to main content

Match Wall Properties

The Match Wall Properties command is used to copy the wall properties from one wall in a room to another. All of the values set using the Query Wall command will be copied.

This command allows you to define one exterior wall with the correct wall type, glass type, and other information set, then copy that definition to all of the other exterior walls in the project. You may need to make some changes on each wall afterward, but most of the values will be set.

To copy the properties from one wall to another, go to
Ribbon: DM HVAC→Rooms and Walls→  Match Wall Properties
Pulldown Menu: DM HVAC→Building Definition→Walls→Match Wall Properties

You will be prompted to select the wall to be copied.

Select source wall:

You will then be prompted to select a wall to which the properties will be copied.

Select target wall:

You will then be prompted to select another wall to which the properties will be copied. Continue to copy wall properties, or press ENTER to finish the command.