To edit the the pipe graphics project list, select:
DM Plumbing 
Customization Pipe Graphics Edit Project List
The Pipe Graphics dialog box will appear.
Pipe Type: the name of the pipe type.
Elbow Graphics: how the pipe type will draw an elbow when two pipes connect at an angle. Click on the field and a drop down menu will display the available options.
The three options are displayed below.
Tee Graphics: how the pipe type will draw a tee when two pipes connect. Click on the field and a drop down menu will display the available options.
The three options are displayed below.
Fitting Ticks: select this box to display tick marks at pipe fittings. The two graphics below show the difference between pipes with and without tick marks.
Linetype Text: text to be inserted as part of the pipe linetype. This text is shown only if the Label Location is set to Above Pipe Line. If the Label Location is set to be in the pipe, the pipe label is used instead.
Linetype Rotate to 0: check this box to have the text always be rotated to 0. The graphic below shows the difference in graphics between when this option is checked and when it is not.
Label Location: this field determines where pipe labels will be placed relative to the pipe they are labeling. There are three options:
| • | Above Pipe Line |
| • | In Pipe Line, Rotated to Match Pipe Angle |
| • | In Pipe Line, Rotated to 0 |
For all three options, it is possible to move the label off the pipe and have it point to the pipe with a leader. The graphic below shows the difference between the different label locations.
