End Horizontal Connection

Top  Previous  Next

The End Horizontal Connection command allows you to connect a fixture to the end of a pipe at whatever angle is necessary. 

To use this command, select:

DM Plumbing4 Fixtures 4 End Horizontal Connection

The program will prompt you to Select pipe to connect:

Click on the fixture you wish to connect to the pipe.  The fixture will highlight when you select it.

You will then be prompted to Select pipe to connect to:

Click on the pipe where you wish to connect the fixture.

fixture connection - end 1

The program will draw the appropriate fixture connections.  See the example below of both vertical and horizontal connections

fixture connection - end 2

Page url: http://www.designmaster.biz/support/plumbing/manual/index.html?end_horizontal_connection.htm