Loop Devices Manually

To manually insert a loop between two devices, go to

DM ElectricalCircuiting and HomerunsLoop Devices Manually

Click to select the first device to loop manually, and then click on the next device. Design Master will draw a loop between the two devices.

At this point Design Master will allow you to loop another device to the second device, or you may press the space bar to close the command.

Loops inserted manually will not have tick marks. You may use the Redraw Tick Marks command to insert them automatically or the Insert Tick Marks command to insert them manually.

Looping devices using this command only draws the loop and does not add them to a circuit.