Display the Hot or Neutral Tick Mark First

The Design Master default is to show the neutral wire first, followed by the hot wires and then the ground. 

To reverse the order of the hot and neutral tick marks, go to

DM ElectricalCustomizationOptionsEdit Project List

Expand the Homerun Options section of the Design Master Electrical Options dialog box.

Go to the Hot or Neutral First line. Under the Value column, use the pulldown menu (see below picture) to select Hot or Neutral, whichever you wish displayed first. Then press OK.

Any new homeruns will display the hot and neutral wires according to your new customization settings. Any existing homeruns will need to be redrawn to make sure they properly display the hot and neutral wires.