Design Master provides two ways to label the light fixtures on a drawing. You may either insert the light fixture callout as a separate entity, or as a part of the light fixture block itself.
To insert a light fixture callout as a separate entity, go to
DM Electrical
Light FixturesInsert Light Fixture Callout
Design Master will prompt you to select the light fixture whose callout you want to insert. Click to select the fixture.
Then you will be asked to locate the callout on the drawing. Click to place the callout and the command is complete.
If you wish to modify a light fixture callout after it has been inserted, the action required to do so depends on how the callout was initially inserted on the drawing. If you inserted the callout as a separate entity from the light fixture itself, you should use standard AutoCAD commands to move, copy, rotate, or erase a light fixture callout. If you inserted the callout as a part of the light fixture block, you will need to use the Design Master command to Move a device label to move the light fixture callout, the command Rotate a device label to rotate the light fixture callout, or the command Erase part of device to erase a light fixture callout. The copy function is not allowed when a callout is inserted as part of the light fixture block. Instead, you will need to copy the entire light fixture.
Follow the links below for more information on how to customize light fixture callouts:
Inserting Callouts as Part of Each Light Fixture
Inserting Callouts After Each Light Fixture
Customizing Light Fixture Callout Blocks