To add a segment to the middle of a feeder, go to
DM Electrical
One Line DiagramAdd Segment to Middle of Wire
Design Master will ask you to "select break point on one line wire". Select the location on the wire where you wish to add the segment. Design Master will insert the segment and a corresponding blue grips location will appear at the selected point . You can then move the feeder into the appropriate position using the new grip that was created.
To add a segment to the end of a feeder, go to
DM ElectricalOne Line DiagramAdd Segment to End of Wire
Design Master will ask you to "select one line wire near end". Where you select the wire will tell Design Master to add a segment from that point to the end closest to that point. Design Master will insert the segment and a corresponding blue grips location, as well as displace the new segment of wire that was inserted. You can then move the feeder into the appropriate position using the new grip that was created.
To remove a segment from a feeder, go to
DM ElectricalOne Line DiagramRemove Segment from Wire
Select the segment to remove. Design Master will erase it and join the next two segments together. This is most likely evidenced only by the removal of a grip on the wire.