Configuring Light Fixtures

This tutorial teaches you how to configure the light fixtures in your drawing so they can be used in photometric calculations.

Open drawing E-3.1.

Insert Light Fixtures

1.Run the Insert Light Fixture command. The Insert Light Fixture dialog box will open.

Ribbon: DM Electrical->Devices-> dm_elec-ltginsert Insert Light Fixture

Pulldown Menu: DM Electrical->Light Fixtures->Insert Light Fixture

2.Set Callout to S.
3.Set Elevation to 20.
4.Check the box for General Light.
5.Press the OK button to close the dialog box.
6.Follow the prompts at the command line to insert light fixtures on the drawing.


Page url:
©2012-2018 Design Master Software, Inc