Moving Distribution Equipment and Feeders

This section teaches you how to move distribution equipment and feeders on the one-line diagram.

Start in the ONE-LINE DIAGRAM drafting view.

Move Distribution Equipment and Feeders

1.Select panel A.
2.Run the Revit Move command.

Modify-> revit--move Move (MV)

3.Move panel A to a new location.
4.Run the Feeder Draw command.

DM One-Line-> dmert-blue-d-16 Feeder Draw

5.Select panel A. The upstream feeder will disappear and you will be prompted to specify the starting location of the new feeder.
6.Follow the prompts to draw a new feeder between panel DP and panel A.
7.Press ESC to finish the command.
8.Repeat steps 1-3 for panel B.
9.Run the Feeder Reset command.

DM One-Line-> dmert-blue-r-16 Feeder Reset

10.Select the feeder between panel DP and panel B. The feeder will disappear and you will be prompted to specify the starting location of the new feeder.
11.Press ESC to insert the feeder using the default connection points.

move-de-feeders


Page url: http://www.designmaster.biz/support/electricalrt/tutorials/2.0/index.html?moving_equipment_and_feeders.htm
©2018-2021 Design Master Software, Inc