Break Circuit

To break a circuit loop graphic without uncircuiting the devices connected by the loop, go to

Ribbon: DM Electrical->Circuiting and Homeruns-> dm_elec-circuitbreak Break Circuit

Pulldown Menu: DM Electrical->Circuiting and Homeruns->Break Circuit

You will be prompted to identify the first break point on the loop to be broken. Select the loop at the point where the break should begin.

Select circuit to break at first break point:

You will then be prompted to select on the loop where the break should end.

Select second break point:

The loop will be broken at the two selected points. The broken loops will be grouped with the device they are connected to. To remove the pieces of the broken loop without deleting the devices, use the Erase Part of Device command.

Related Options

Circuit break block: Sets the block used for the break in the circuit.

Page url:
©2012-2023 Design Master Software, Inc