Insert Light Fixture |
Up Previous Next |
To insert a light fixture on a drawing, go to Ribbon: DM Electrical->Devices-> Pulldown Menu: DM Electrical->Light Fixtures->Insert Light Fixture Insert Light Fixture Dialog Box Group: The active light fixture group. The items listed in the Callout list are based upon the active light fixture group. The list of groups available is defined in the Light Fixture Project Schedule command. Callout: The type of light fixture to be inserted. The list of light fixtures available is defined in the Light Fixture Project Schedule command. The selected callout controls the values displayed in the top-right of the dialog box. See the Common Light Fixtures Information section for more information about these values. To change these values, you must change the definition of the light fixture type in the project schedule. Elevation: The elevation of the light fixture. See the Elevation section for more information. The elevation is used as the mounting height of the light fixture when calculating point-by-point photometrics. See the Point-by-Point Photometrics section for more information. Layer System: See the Layer System section for more information. Exempt: Whether the light fixture is exempt from energy calculations.
See the Exempt Light Fixtures section for more information. General Light: Whether the light fixture is included in general point-by-point photometric calculations. See the Point-by-Point Photometrics section for more information. Egress Light: Whether the light fixture is included in egress point-by-point photometric calculations. See the Point-by-Point Photometrics section for more information. Tilt: The angle in degrees at which the light fixture is tilted. The rotation is in the direction of the insertion angle of the light fixture. If the light fixture has multiple heads, the Tilt will be applied to each head in its oriented direction. Roll: The angle in degrees at which the light fixture is rolled. The rotation is perpendicular to the direction of the insertion angle of the light fixture. If the light fixture has multiple heads, the Roll will be applied to each head perpendicular to its oriented direction. Inserting the Light Fixture on the Drawing To insert a light fixture on the drawing, press the OK button. The settings specified in the dialog box will be used for the inserted light fixture. You will be prompted to identify where on the drawing the light fixture is to be inserted. Specify insertion point: You will then be prompted for the rotation angle. If the light fixture block is not able to be rotated, this prompt will be skipped. Specify rotation angle <0>: You will then be prompted to insert another light fixture of the same type. Continue to insert light fixtures, or press ENTER to finish the command.
|
Page url:
http://www.designmaster.biz/docs/elec/index.html?insert_light_fixture.htm
©2012-2023 Design Master Software, Inc |