Insert Photometric Solid: Shape

The Insert Photometric Solid: Shape command is used to insert light-obstructing objects that are closed but not rectangular. If the Starting Elevation is 0, any illuminance levels inside the shape will not be printed. Most photometric solids will be inserted using this command, as most buildings and other objects on your plans will require a non-rectangular shape.

To define a photometric solid shape, go to

Ribbon: DM Electrical->Point-by-Point Photometrics-> dm_elec-photoshape Insert Photometric Solid: Shape

Pulldown Menu: DM Electrical->Point-by-Point Photometrics->Insert Photometric Solid: Shape

Insert Photometric Solid: Shape Dialog Box

point-by-point-photometrics--insert-photometric-solid-shape-dialog-box

See the Common Photometric Solid Information section for more information about the values in this dialog box.

Enter the relevant information into the dialog box and press the OK button. You will be prompted to draw the solid shape on the drawing.

Specify first point of solid shape:

You will then be prompted to specify the next point of the solid.

Specify next point:

You can specify additional points or press ENTER to complete the shape. The solid shape will be displayed on the drawing and included in the photometric calculations.


Page url: http://www.designmaster.biz/docs/elec/index.html?insert_photometric_solid_shape.htm
©2012-2023 Design Master Software, Inc