Conduit and Cable Tray Elevation Labels

This section describes the options available in the Conduit and Cable Tray Elevation Labels group in the Design Master Electrical Options dialog box.

customization--conduit-cable-tray-elevation-labels-options-dialog-box

Leader graphic: The block that is used for elevation label leaders.

Leader location: Where the leader points on the conduit or cable tray.

Edge: The leader points to the edge of the conduit or cable tray as shown below.

Customization--Options.Elevation Labels.Edge example

Center: The leader points to the center of the conduit or cable tray as shown below.
Customization--Options.Elevation Labels.Center example

Top block: The block used for the elevation label when the Insert Top Elevation Label command is used.

Bottom block: The block used for the elevation label when the Insert Bottom Elevation Label command is used.

Both block: The block used for the elevation label when the Insert Top and Bottom Elevation Label command is used.

Centerline block: The block used for the elevation label when the Insert Centerline Elevation Label command is used.

Top label: The text that is used to display the top elevation in the label. $ELEV is replaced with the elevation.

Bottom label: The text that is used to display the top elevation in the label. $ELEV is replaced with the elevation.

Centerline label: The text that is used to display the top elevation in the label. $ELEV is replaced with the elevation.


Page url: http://www.designmaster.biz/docs/elec/index.html?options_elevation_labels.htm
©2012-2023 Design Master Software, Inc