Insert Bottom Elevation Label

The Insert Bottom Elevation Label command is used to insert an elevation label on a duct that displays the elevation of the bottom of the duct.

To insert a bottom elevation label on a duct, go to

Ribbon: DM HVAC->3D-BIM-> dm_hvac-insertBottomElevationLabel Insert Bottom Elevation Label

Pulldown Menu: DM HVAC->3D-BIM->Insert Bottom Elevation Label

You will be prompted to identify which section of duct is to be labeled.

Select duct to insert elevation label on:

You will then be prompted to specify the location of the bottom elevation label on the drawing. See the Inserting Notes and Leaders on the Drawing section for more information about inserting the label.

Related Options

Leader graphic: Sets the block used for elevation label leaders.

Leader location: Sets whether leaders snap to the edge or center of ducts.

Bottom block: Sets the block used for the bottom elevation label.

Bottom label: Sets how the bottom elevation is displayed on the label.

Include exterior insulation thickness in elevation: Sets whether the bottom elevation accounts for exterior insulation.

Page url:
©2012-2023 Design Master Software, Inc