Offset Vertical Duct
|Up Previous Next|
The Offset Vertical Duct command is used to insert a vertical duct connected to a horizontal duct that has its Horizontal Alignment set to Left or Right. See the section for more information about this setting.
To insert an offset vertical duct, go to
Ribbon: DM HVAC->Ducts-> Offset Vertical Duct
Pulldown Menu: DM HVAC->Duct Centerlines->Offset Vertical Duct
You will be prompted to select the horizontal duct to which the vertical duct will connect.
Select duct or label to connect vertical duct to:
You will then be prompted to specify the location of the vertical duct.
Specify insertion point for vertical duct:
The Offset Vertical Duct dialog box will appear.
Ending Elevation: The elevation of the end of the vertical duct. See the section for more information.
Enter the desired ending elevation and press the OK button. A duct centerline representing the vertical duct will be inserted perpendicular to the selected horizontal duct. The vertical duct will be drawn at the end of the newly inserted duct.
©2012-2023 Design Master Software, Inc