Default Fittings

This section describes the options available in the Default Fittings group in the Design Master HVAC Options dialog box.

customization--default-fittings-options-dialog-box

Rectangular elbow: The default fitting used for elbows in rectangular ducts.

Square elbow: A Square Elbow fitting is used. See Turning Vanes on Square Elbows and Wyes in the Fittings options section for whether the elbow includes turning vanes.
Radius elbow: A Radius Elbow fitting is used. See Radius for Elbows in the Fittings options section for the radius used for the elbows.

Rectangular branch: The default fitting used for a single takeoff in a rectangular duct.

Any angle tee: A Variable Angle Branch fitting is used.
Boot tee: A Boot Tee fitting is used.
Conical tee: A Conical Tee fitting is used.
Straight takeoff: A Straight Tee fitting is used.
Wye: A Wye / Bullnose Tee fitting is used.
Transition tee: A Transition Tee fitting is used.

Rectangular cross: The default fitting used for a cross in a rectangular duct.

Boot tee: A Boot Tee fitting is used.
Conical tee: A Conical Tee fitting is used.
Straight takeoff: A Straight Tee fitting is used.
Transition tee: A Transition Tee fitting is used.

Round elbow: The default fitting used for elbows in round and flat oval ducts.

Square elbow: A Square Elbow fitting is used. See Turning Vanes on Square Elbows and Wyes in the Fittings options section for whether the elbow includes turning vanes.
Radius elbow: A Radius Elbow fitting is used. See Radius for Elbows in the Fittings options section for the radius used for the elbows.

Round branch: The default fitting used for a single takeoff in a round or flat oval duct.

Any angle tee: A Variable Angle Branch fitting is used.
Boot tee: A Boot Tee fitting is used.
Conical tee: A Conical Tee fitting is used.
Straight takeoff: A Straight Tee fitting is used.
Wye: A Wye / Bullnose Tee fitting is used.
Transition tee: A Transition Tee fitting is used.

Round cross: The default fitting used for a cross in a round or flat oval duct.

Boot tee: A Boot Tee fitting is used.
Conical tee: A Conical Tee fitting is used.
Straight takeoff: A Straight Tee fitting is used.
Transition tee: A Transition Tee fitting is used.

Transparent Ducts: The fitting inserted in the previous duct before a transparent duct. See the Previous and Next Ducts section for information about determining which duct is the previous duct.

End Cap: An End Cap fitting is inserted at the end of the previous duct.
None: No fitting is inserted at the end of the previous duct.

Page url: http://www.designmaster.biz/docs/hvac/index.html?options_default_fittings.htm
©2012-2023 Design Master Software, Inc