45-90 Vertical at Wall

The 45-90 Vertical at Wall command is used to insert a connecting pipe at a 45-degree angle to the pipe, which then turns 90 degrees to connect to the fixture. The connecting pipe will rise or drop inside a wall from the elevation of the pipe to the elevation of the fixture.

To make a 45-90 connection with a vertical pipe in a wall, go to

Ribbon: DM Plumbing->Fixtures-> dm_plumb-fixtureConnection-single9090-wall 45-90 Vertical at Wall

Pulldown Menu: DM Plumbing->Fixtures->45-90 Vertical at Wall

You will be prompted to identify which fixture to connect to a pipe.

Select fixture to connect:

You will then be prompted to select the pipe to which the fixture will be connected.

Select pipe at connection point:

You will then be prompted to select two points inside the wall in which the vertical pipe will be inserted.

Specify first point inside wall where vertical pipe will be located:
Specify second point inside wall where vertical pipe will be located:

The fixture and the pipe will be connected.

Related Options

Break width: Sets the width of the break in a pipe if it is overlapped by another pipe.

Vertical pipe drafting method: Sets how vertical pipes are drawn.

This option can be further customized with the Minimum vertical pipe diameter and Not to scale vertical pipe diameter options.

Page url: http://www.designmaster.biz/docs/plumb/index.html?45_90_vertical_at_wall.htm
©2012-2023 Design Master Software, Inc