Segment Trim/Extend

Allows you to connect two disconnected, non-parallel circuit segments on the riser diagram, similar to the Revit Trim/Extend to Corner command.

You will be prompted to specify a circuit segment.

Select the first circuit segment to trim or extend:

You will then be prompted to specify a second circuit segment.

Select the second circuit segment to trim or extend:

If one or both circuit segments need to be trimmed, you will then be prompted to specify a point on the drafting view inside the corner where you want the circuit segments to connect.

Specify point on inside of corner made by circuit segments:

The circuit segment lengths will be adjusted to form a corner.