Skip to main content

Aim Light Fixture

The Aim Light Fixture command is used to aim a light fixture at a specific point on the ground.

To aim a light fixture, go to
Ribbon: DM Electrical→Point-by-Point Photometrics→  Aim Light Fixture
Pulldown Menu: DM Electrical→Point-by-Point Photometrics→Aim Light Fixture

Select the light fixture to be aimed.

Select light fixture:

You will then be prompted to specify the location on the ground where the light fixture will be aimed.

Select point to aim light fixture towards:

The light fixture will be rotated on the drawing in the direction of the specified point. If the light fixture has multiple heads, the head facing the insertion angle of the light fixture will face the specified point, and the other heads will rotate by the same angle.

The Tilt will be adjusted based upon the light fixture elevation to point toward the specified point.

The Roll will be set to 0.

See the Insert Light Fixture section for more information about the Tilt and Roll settings.