3D-BIM
This section describes the commands available to perform 3D-BIM modeling and analysis.
Commands
📄️ Draw 3D Pipes
The Draw 3D Pipes command is used to draw the 3D pipes for all of the pipes in a system.
📄️ Erase 3D Pipes
To erase the 3D graphics for a pipe run, go to
📄️ Insert Hanger
To insert a hanger on a pipe, go to
📄️ Move Hanger
To move a hanger to a new location on a pipe, go to
📄️ Remove Hanger
To remove a hanger from a pipe, go to
📄️ Insert Top Elevation Label
The Insert Top Elevation Label command is used to insert an elevation label on a pipe that displays the elevation of the top of the pipe.
📄️ Insert Bottom Elevation Label
The Insert Bottom Elevation Label command is used to insert an elevation label on a pipe that displays the elevation of the bottom of the pipe.
📄️ Insert Top and Bottom Elevation Label
The Insert Top and Bottom Elevation Label command is used to insert an elevation label on a pipe that displays the elevation of the top and the bottom of the pipe.
📄️ Insert Centerline Elevation Label
The Insert Centerline Label command is used to insert an elevation label on a pipe that displays the elevation of the center of the pipe.
📄️ Move Elevation Label
The Move Elevation Label command is used to move an elevation label on a pipe.
📄️ Export Entire Project to IFC File
The Export Entire Project to IFC File command is used to export all of the 3D-BIM elements from a project to a single IFC file. The IFC file format is recommended for 3D collision detection in Revit.
📄️ Export Drawing to IFC File
The Export Drawing to IFC File command is used to export all of the 3D-BIM elements from the current drawing to an IFC file. The IFC file format is recommended for 3D collision detection in Revit.
📄️ Export One Area to IFC File
The Export One Area to IFC File command is used to export all of the 3D-BIM elements from a single alignment point area to an IFC file. The IFC file format is recommended for 3D collision detection in Revit.
📄️ Export Entire Project to DWG File
The Export Entire Project to DWG File command is used to export all of the 3D-BIM elements from a project to a single DWG file. The DWG file format is recommended for 3D collision detection in Navisworks.
📄️ Export Drawing to DWG File
The Export Drawing to DWG File command is used to export all of the 3D-BIM elements from the current drawing to a DWG file. The DWG file format is recommended for 3D collision detection in Navisworks.
📄️ Export One Area to DWG File
The Export One Area to DWG File command is used to export all of the 3D-BIM elements from a single alignment point area to a DWG file. The DWG file format is recommended for 3D collision detection in Navisworks.