End Vertical Connection
|Top Previous Next|
The End Vertical Connection command allows you to connect a fixture to the end of a pipe at whatever angle is necessary.
To use this command, select:
DM Plumbing4 Fixtures 4 End Vertical Connection
The program will prompt you to Select pipe to connect:
Click on the fixture you wish to connect to the pipe. The fixture will highlight when you select it.
You will then be prompted to Select pipe to connect to:
Click on the pipe where you wish to connect the fixture.
The program will draw the appropriate fixture connections. See the example below of both vertical and horizontal connections
|Page url: http://www.designmaster.biz/support/plumbing/manual/index.html?end_vertical_connection.htm|