Training Recording: Electrical Mailbag May 2020 « Knowledge Base

Free Trial Try Design Master for 30 Days

Training Recording: Electrical Mailbag May 2020

Thursday, May 28th, 2020

How to disconnect distribution equipment, configure feeder and service loads, and more in Design Master Electrical for AutoCAD.

We answer the following questions:

“Why do I have two feeders with the same callout but different feeder IDs?” (00:45)
“How do I disconnect a panel that’s connected to another panel?” (03:43)
“Why does the Largest Motor load on the panel schedule show a demand factor of 25% and not 125%?” (04:47)
“Why does the dwelling unit lighting load show up as Other Load on the panel schedule?” (09:25)
“Can I configure a device schedule to only show information, such as mounting height, for some devices and not others?” (13:15)

Awesome, share it:

Thanks!

We appreciate your feedback.

Filter by

Post Page

Training Recording Electrical RT Electrical RT Training Electrical RT General Electrical Electrical Training

Sort by

Training Recording: Electrical RT 2.0 Beta 8 Features

This training video shows you the improvements made in Design Master Electrical RT 2.0 Beta 8.

Training Recording: Breaker Curves in Revit

This training video shows you how to set breaker curves for performing selective coordination and calculating arc-flash trip times in Design Master Electrical RT 2.0.

Training Recording: Customizing Families (ft. Brian Muir)

This training video teaches you how to customize your families in Design Master Electrical for Revit, and more. This training was led by Brian Muir, P.Eng., of Muir Engineering.

Training Recording: Wire Sizing

This training video teaches you how wire sizing works in Design Master Electrical.

Training Recording: Circuit Descriptions

This training video teaches you how to manage circuit descriptions in Design Master Electrical RT.

Training Recording: Fault Calculations

Learn about short-circuit analysis in our software. See how we calculate the fault at panels and the factors that impact the outcome.