Training Recording: Transformer OCP Sizes « Knowledge Base – Design Master Software

You are here: Home > Support > Knowledge Base > Training Recording: Transformer OCP Sizes

Training Recording: Transformer OCP Sizes

Thursday, February 11th, 2021

How to configure OCP sizing for transformers in Design Master Electrical RT 2.0.

We look at the following topics for the Transformer OCP Sizes command:

Why the Transformer OCP Sizes command exists (00:32)
Setting transformer sizes for which the OCP is sized and which transformer sizes are listed in the Panel Edit command (01:50)
Setting OCP sizes based upon transformer size and number of phases (02:56)
Setting transformer OCP sizes for future projects using Revit templates or the Export command (05:17)

We also answer the following question:

“Is there a shared parameter I can use to make an if() formula based upon the panel’s main disconnect type?” (06:01)
- Knowledge base article on writing Revit formulas based upon the main disconnect type

Awesome, share it:

Thanks!

We appreciate your feedback.

Related Articles

Filter by

Post Page

Training Recording Electrical RT Electrical RT Training Electrical RT General Electrical Electrical Training

Sort by

Training Recording: Electrical RT 2.0 Beta 8 Features

This training video shows you the improvements made in Design Master Electrical RT 2.0 Beta 8.

24

Training Recording: Breaker Curves in Revit

This training video shows you how to set breaker curves for performing selective coordination and calculating arc-flash trip times in Design Master Electrical RT 2.0.

24

Training Recording: Customizing Families (ft. Brian Muir)

This training video teaches you how to customize your families in Design Master Electrical for Revit, and more. This training was led by Brian Muir, P.Eng., of Muir Engineering.

24

Training Recording: Wire Sizing

This training video teaches you how wire sizing works in Design Master Electrical.

24

Training Recording: Circuit Descriptions

This training video teaches you how to manage circuit descriptions in Design Master Electrical RT.

24

Training Recording: Voltage Drop in Revit

Learn how Design Master calculates voltage drop. Dig in to both the calculations themselves and all the settings that you can adjust.

18

8000 Regency Parkway, Suite 585
Cary, NC 27518

[email protected]

©2001-2023, Design Master Software, Inc